How to Prime and Replace GeekVape Super Mesh Coils

By VaporFi | Online Vape Shop - Vapes, Kits & E-Liquid | Published: 2026-11-05

Category: أدلة إرشادية

Learn how to prime GeekVape Super Mesh coils and replace them correctly. Follow our step-by-step guide to avoid dry hits and extend coil life.

Quick answer

Prime GeekVape Super Mesh coils by saturating the cotton completely with e-liquid, then let the coil sit for 10–15 minutes before vaping. Replace the coil when you notice a burnt taste, muted flavor, or reduced vapor production.

Why mesh coils need careful priming

Mesh coils use a larger surface area than traditional wire coils, which can deliver better flavor and vapor—but also means the cotton must be thoroughly saturated to avoid dry hits. Skipping the priming step can burn the cotton instantly, ruining the coil before you even take a puff.

Signs it's time to replace your Super Mesh coil

A burnt or harsh taste is the clearest sign, but don't wait for that. If flavor drops off noticeably or vapor production decreases, it's time for a new coil. Dark, discolored e-liquid in the tank can also indicate a coil that's past its prime.

Step-by-step: priming and replacing Super Mesh coils

Prepare your device: Disassemble the tank and remove the old coil. Wipe any excess e-liquid from the threads and base. Check the O-rings for damage; a worn O-ring can cause leaks even with a new coil.
Install the new coil: Thread the new Super Mesh coil into the base firmly, but do not overtighten. Reassemble the tank. Hand-tighten only—over-tightening can damage the coil or threading.
Prime the coil: Drip e-liquid directly onto the exposed cotton until it is fully saturated. Also add a few drops inside the coil head if visible. Don't rush—dry spots lead to burnt hits. Let it sit for 10–15 minutes before vaping.
Fill the tank and wait: Fill the tank with e-liquid and let it stand for 10–15 minutes to allow the cotton to absorb fully. Resist the urge to vape immediately; patience here prevents a burnt coil.
Start at low wattage: Begin vaping at a lower wattage than your usual setting, then gradually increase over the first few puffs. This helps break in the coil and avoids overheating the fresh cotton.

Product facts

GeekVape Super Mesh Replacement Coils - (5 pack) | VaporFi: GeekVape Super Mesh Replacement Coils come in a 5-pack. Having five coils on hand means you can replace worn coils without delay and always keep a spare.
GeekVape Super Mesh Replacement Coils - (5 pack) | VaporFi